Damage may have been minimal, but the
second fire in seven months at a local aluminum foundry has officials there
thinking deep spring cleaning.
Firefighters
were called to Casting Technologies Co., on a possible fire in the ceiling.
Spring Lake
Township Fire Chief said although smoke was heavy, the main fire
was mostly out when firefighters arrived.
Fire Chief said it
appeared that a hydraulic line started leaking and the oil ignited due to
extreme heat in the area. That caught dust on fire and the fire was sucked up
through the exhaust fans.
Plant Manager confirmed that three exhaust fans, some lights and wiring were
destroyed in the fire. Damage was estimated at less than $5,000. The plant manager agreed
that the fire may have been caused by a hydraulic line leak, but that the cause
was still under investigation.
Monday’s fire
was similar to one at the plant in July 2011, when seven area fire departments
were on the scene for hours to battle a series of small blazes in the plant.
On Monday,
Spring Lake Township was assisted by the Crockery Township and Ferrysburg fire
departments at the scene.
Fire Chief said
firefighters remained on site for three hours because the work was so
labor-intensive. While one group of firefighters was lifting dry chemical
extinguishers to the roof, another group was inside crawling on the beams to
get all the fire out, Nuvill said.
Fire Chief said
there was an accumulation of dust in the beams throughout the plant, largely
due to the facility’s age.
“Part of the facility was built in the 1940s,” the plant manager said. “It was added onto almost every decade since then.”
He said
removing the dust from the roof area is part of the corrective actions being
planned.
Fire Chief said
everyone was evacuated safely from the facility and that production was down
for only two hours. Apple Drive
was closed to traffic for the three hours that firefighters were on the scene.
North Ottawa
Community Hospital paramedics and the Ottawa County Sheriff’s Department also
assisted at the scene.
No comments:
Post a Comment
Thank you for commenting on the Aluminium Plant Safety Blog!